Fosi Audio Support
Categories
Promoted articles
- The V3 Mono has three op-amps. What does each one do? And if l want to get abetter sound, which one should l change?
- What is the input voltage of the included power supply, and can it be used in my country?
- How are you synchronizing the TPA3255 oscillator between the monoblocks in order to avoid Class D "Beat Tones" ?
- What is the input impedance of the V3 Mono?
- A KOL pointed out that the V3 Mono runs really hot to the toúch. ls that a safety concern?
- If you use a single 48V/10A power supply to power two V3 Mono devices simultaneously, compared to using two separate 48V/5A power supplies for each V3 Mono, will the output power be the same? Will there be any changes in other parameters?
- When powering a V3 Mono device, would using a 48V/10A power supply provide a higher power output than a 48V/5A power supply?
- What's the input sensitivity of the ZA3?
- I connect to the Pre-Out from the amp to the LFE on the powered Polk PSW110 subwoofer. But there is no sound.
- The differences in terms of BT30D and BT30D PRO’s Sub out and Pre out functionality.
- Power Output with Various PSUs
- What type of DC-plug I need to buy for power supply?
- Can I use different impedances in each part? Like 4ohms in the stereo output and 8ohms in the subwoofer output?
- Only one port on the powered sub.
- What’s the sub frequency position relative to the dial?
- How different op-amp chips affect sound signature, including the NE5532, Sparkos SS3602, and MUSES02?