ZA3
- What's the input sensitivity of the ZA3?
- How many op amps should l change in ZA3?
- How to set up a system using two ZA3 units in mono mode?
- Which opamps do you recommend for the most excellent results?
- Connecting powered Subwoofer to ZA3s in Monoblock Mode: Does It Matter Which ZA3?
- If I don't have a source trigger, do I need to turn off each amp using the knob?
- Can ZA3 handle 2 ohm?
- Can they be stacked, one on top of the other or more, is this ok?
- Power Output with Various PSUs
- I can’t get the front button off regardless of how hard I pull.
- How/where to position volume knobs on two Za3 when used as monoblocks?
- What cable(s) would I need to trigger two ZA3s both being used in mono mode?
- 12V trigger in used for?
- The 12V control on the ZA3 does not turn on?
- Is the SUB OUTPUT Volume controlled by the volume control on the ZA3?
- When you use mono mode, does it disable the volume control?
- The characteristics of the Taper A potentiometer.
- SUB OUT to powered subwoofer
- What is the crossover frequency for the rca subwoofer out on the back?
- No front light on ZA3 though there is light on the AC adapter.
- Can you confirm the required mA power needed for the 12v trigger to operate?
- What cable(s) would I need to trigger two ZA3s both being used in mono mode?
- Op-Amps Upgrade for XLR Input on 2 ZA3 in Mono
- What are the Op-amps of the ZA3 serving and what channel?