V3 MONO
- The V3 Mono has three op-amps. What does each one do? And if l want to get abetter sound, which one should l change?
- What is the input voltage of the included power supply, and can it be used in my country?
- How are you synchronizing the TPA3255 oscillator between the monoblocks in order to avoid Class D "Beat Tones" ?
- What is the input impedance of the V3 Mono?
- A KOL pointed out that the V3 Mono runs really hot to the toúch. ls that a safety concern?
- If you use a single 48V/10A power supply to power two V3 Mono devices simultaneously, compared to using two separate 48V/5A power supplies for each V3 Mono, will the output power be the same? Will there be any changes in other parameters?
- When powering a V3 Mono device, would using a 48V/10A power supply provide a higher power output than a 48V/5A power supply?
- Do Burson discrete op-amps work in the Fosi V3 Mono?
- What are the fosi v3 mono block dimensions?
- Power Output with Various PSUs (Refer to the image below)
- The power LED does not work but outputs sound
- For the V3 Mono do I need any specific type of op-amp?
- Filter Requirement with Separate Power Supplies
- Ordering Y-Adapter Splitter and Power Filter
- I’m looking to purchase two Fosi V3 Monos and prefer not to share the PSU.
- Official Statement Regarding the Inverted Phase of the V3 Mono
- ⚠️ Please ensure the power is off when plugging in the speaker cable.
- Does the xlr input accept a standard xlr balanced audio cable?
- I have a Dac/pre with TRS balanced output. How can I connect to the V3 Mono?
- I purchased 2 V3 mono and 2 48V/10A bricks. How will the V3 mono run with one brick each? Will it hurt them and is it safe?